LAUNCH TECH TWC-502RMB Manual page 14

LAUNCH
Slowly and repeatedly depress the inflation pedal U
l
（Fig.01-1）shortly (to avoid over-high pressure) to
make sure that the reading on pressure gauge
meets manufacture's requirements. The pressure
should not exceed 3.5 bar. The user may adjust the
reducing valve in the machine to get different
pressures according to requirements.
l If the tyre has no the tube and tyre does not match
the rim hermetically,
above-mentioned will has no effect. In this case, the
quick-inflation should be adopted. The quick-inflation
method is to depress the inflation pedal U （Fig.01-1）
right-hand of the cabinet to its end and loose the
pedal quickly. The quick-inflation is finished with a
rat-tat.
l If the pressure exceeds the limit, press the button on
the barometer so that the pressure goes down to
what is required.
Caution: Danger of explosion!
The safety procedures should be closely followed.
Review and abide by the following instructions.
Otherwise serious injury or death can be resulted.
The manufacturer shall not be held responsible for
any possible accident when the safety procedures are
not followed.
u Carefully check the dimensions of rim and
tyre to see if they match each other. Check
and make sure that the tyre is not worn or
damaged before inflation.
u When a high pressure is required, remove the
tyre from the tyre changer and resume the
inflation in a special protective hood.
u Be careful when inflating the tyre. Keep
hands and the rest of human body away from
tyre.
inflation method
9
Tyre Changer (TWC-502RMB)