Inflating Tyre - LAUNCH TECH TWC-502RMB Manual

LAUNCH
To install the upper tyre bead, place the tyre well and
l
readjust position of the tyre bead (same as mount of
the lower tyre bead in Fig. 24). Draw out the roller-2
and make its side surface 1—2cm away from
margin of the rim, than press the lock-button to lock
the roller arm. Place the press block on the upper
bead 20cm clockwise away from the mount/demount
head. Press the rise/fall control lever to make the
press block go down 5—7cm to press the tyre bead
into the rim groove (Fig. 25). Fig.26 is the section
figure of the operation.
Fig.24
Fig.26
l
Depress the pedal J (Fig.22) to turn the turntable
while keeping pressing on the tyre. When only 10—
15cm(Fig.27) is left, slow down to avoid damage of
the tyre bead. Stop the motor if there is any
indication for damage. Lift the pedal J and turn the
turntable counter-clockwise. Try again when the tyre
is back to the original shape.
Fig.25
Attention:
u If the rim size does not change, it is not
necessary to loose the locking handle
after finishing the mount and demount of
the tyre and adjust the mount/demount
head before mount and demount of tyre.
The operation will be continued by
depressing the column tilting control
pedal to make the titling column let go
and restore automatically.
u Make sure nobody is behind the tilting
post when depressing pedal (G).
u In the process of clamping, keep head
and hands away from the area between
the tyre and the horizontal arm in case of
injury.

Inflating tyre

Danger!!
Inflating can be highly dangerous. Take precautions
and pay close attention to the procedures. Check if
the compressed air is well connected before inflating.
The machine is equipped with a gauge to read the
pressure in the tyre.
l Loose the wheel on the turntable.
l Connect the outlet of the barometer (mounted on
tilting column) to the air inflation valve.,shown in
Fig.28.
8
Tyre Changer (TWC-502RMB)
Fig.27
Fig.28