Advertisement
Quick Links
Advertisement
Related Manuals for Premium LID MX40P
Summary of Contents for Premium LID MX40P
- Page 1 MX40P Mercedes-Benz X Class Dual Cab MX40P Page 1 of 12...
- Page 2 Fitting Instructions Part Number MX40P. Mercedes-Benz X Class Dual Cab 2017+ Check contents of kit before commencing fitment and report any discrepancies *Image example shown only • Do not stand/sit or rest heavy objects on Tonneau Cover • Humans or animals are not to be under the closed Tonneau at any given time •...
- Page 3 Installation Steps Flow Chart START TUB PREP FOR LID INSTALL LID INSTALL AND ADJUSTMENT FINISH MX40P Page 3 of 12...
- Page 4 Thoroughly clean installation areas. Important: Instructions are for Utes with an UNDER-RAIL tubliner. If you have an OVER-RAIL tubliner you must trim the top off. Find centre and mark position. MX40P Page 4 of 12...
- Page 5 Measure and mark the positions as indicated above from the centre of the bed for placement of the bottom hinges. WARNING: RECHECK DIMENSIONS TO ENSURE CORRECT MEASURENT Drive the self-tapping screws through the holes in the top and the base of the hinge plate into the tub. Tighten to 3Nm. MX40P Page 5 of 12...
- Page 6 IMPORTANT: Position extrusion as close to the header rail rear radius. Rub down firmly to ensure maximum adhesion. Important: DO NOT over tighten screws. Recommended tightening torque is 1- 3 Nm MX40P Page 6 of 12...
- Page 7 When lid is aligned correctly, secure the catch hinge to the lid using 4 M8 Thick Washers and M8 Bolts Important: Ensure tongues are fully inserted into the hinge slots with hinge pin securely in place. MX40P Page 7 of 12...
- Page 8 Fig. 9 - Attach gas strut Important: If you have purchased a Central Locking Ute Lid please ignore the next page concerning Lock Bracket Installation and Lock Bracket adjustment. MX40P Page 8 of 12...
- Page 9 Loosen 2 screws and slide catch to align correctly with latch bar. Tighten screws to secure in place. Adjust nuts on latch bar to alter height of bar to suit. Repeat for the opposite side. MX40P Page 9 of 12...
- Page 10 Cut off excess cable making sure to leave 20mm from locking allen key bolt. MX40P Page 10 of 12...
- Page 11 MX40P Page 11 of 12...
- Page 12 Wash Hard Tonneau Cover using water and normal carwash detergent and polish with an automo- tive polish. Please ensure Lid is kept locked at all times when not being used, for both safety and longevity. NOTE: Having trouble? Call your Supplier. MX40P Page 12 of 12...
Need help?
Do you have a question about the MX40P and is the answer not in the manual?
Questions and answers