Components
•
JTECH Transmitter
Applies to models: IQ Base, NEO, IStation
•
CommPass Pagers
•
CommPass Charger
Step 1
Lock the antenna to the connector on the
transmitter by placing the antenna on the
connector and twisting left to lock in place.
Step 4
Add pagers to slots. You will see a BLUE light on
each pager. This light indicates the charging
status.
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
®
GuestCall
Paging w/CommPass Pagers
Step 2
Plug the power supply into the transmitter and
then into a standard 110-240v outlet. A surge
protector is recommended.
•
'LO' on the number display: Battery is below 20% charged and SHOULD NOT be used.
•
Flashing BLUE: Pager is charging and CAN BE used.
•
Solid BLUE: Pager is fully charged.
•
Allow 4 hours for a complete charge of the pagers.
Quick Setup Guide
Connector Wire
Step 3
Compile charger bases and connector wires if
applicable. Plug charger power supply into
charger and then into a standard outlet. Surge
protection is recommended for charging bases.
QSGCCP-1
Need help?
Do you have a question about the JTECH GuestCall and is the answer not in the manual?
Questions and answers