Table of Contents
Advertisement
Other operating
instructions
For a rinse and spin
For a drain and spin
You may need
an extra rinse and
spin for heavily
soiled
loads which
need more detergent.
(Extra de-
tergent
can require
an extra rinse.]
l
Push Control
Knob in.
l
Turn clockwise
to any*
on the dial
See above
drawing.
l
Pull Control
Knob out.
l
The washer will fill to selected
level; agitate
2 minutes; drain
and spin.
Your washer
can be set to drain
and spin out water.
l
Push Control
Knob in.
l
Turn clockwise
to the bar just before
OFF in any cycle.
See above
drawing.
l
Pull Control
Knob out.
l
The washer
will drain and spin.
For agitation
and spin speeds
in each
cycle,see
pages
6-9.
For
a soak or pre-wash
For best results, use warm water
for soaking
or pre-washing
stained
laundry. Hot water
can set stains.
. Use recommended
amount
of
detergent
or pre-soak
product.
l
Push Control Knob in.
l
Turn clockwise
to point at a number
in the SOAK Cycle...use
the &minutes
mark for a pre-wash:
l
Pull Control Knob out to start washer.
l
When the cycle
is over, add de-
tergent
for the next selected
wash
cycle. The SOAK Cycle
should
always
be followed
by a Wash
Cycle.
l
Set the washer
and start the next
selected
wash cycle.
Important:
See additional
care information
on page
7 of your
"laundry
Guide!'
10
'To start soak or pre-wash
with agitation,
the Cycle
Control
Knob
must point to a number
in the SOAK Cycle.
Advertisement
Table of Contents
