IMPORTANT SAFETY INSTRUCTIONS OPERATING INSTRUCTIONS.. Starting Your Washer What Happens in Each Cycle OTHER OPERATING INSTRUCTIONS For a Rinse ancl Spin For a Drain and Spin 01987 Whirlpool Parts and features LAUNDRY LOAD TEMPERATURE SIZE INFORMATION SELECTOR CENTT ‘-//““,E; PJ$!-$!~ AGITATOR ’...
Additional Safety Instructions ALWAYS store detergent, laundry aids other materials in a cool, place where children can’t reach them - in a locked cabinet if possible. ALWAYS read and follow instructions on packages of detergent and laun- dry aids - especially warnings precautions.
Operating instructions Starting Your Washer Be sure to measure and add detergent, a sorted load in the washer . Select a LOAD SIZE Turn the knob to point to a setting that describes the size of load you want to wash. Set the knob on or between EX SMALL (a few small items] and LARGE (a full load].
Select CYCLE and WASH TIME; . Start the washer Push in the Control Knob and turn it to the right. It must be pushed and turned only clockwise. Start the washer by pulling the Control Knob. The washer will fill to the level you set with wash water of the selected temper- ature.
What Happens in Each Cycle* Each cycle has different agitation and spin speeds kinds of fabrics. Numbers on the dial in each cycle agitation time. When the Cycle Control Knob is set to a number before agitation and timing starts. After agitation until it points to OFF and the cycle ends, REGULAR HEAVY Cycle...
NOTE: You may hear the sound of water spraying cycles. In some cycles, cold water is sprayed the rinsing. Gentle Wash System For better fabric care in the REGULAR and PERMANENT PRESS cycles, the agitation speed is reduced during the last few minutes of wash time. NOTE: Always use cold rinse water for permanent...
KNITS/GENTLE Cycle A cycle that gently washes and spins lightly to moderately soiled delicate fabrics washable knits. SOAK Cycle Brief periods of agitation and soak time help remove heavy soils and certain stains that need extra pretreatment. Use recom- mended amount detergent or pre-soak...
I’ 1’ LCycle Special care is needed when soaking See your “Laundry Guide” for proper The washer will proceed REGULAR/HEAVY Cycle. want a different SUPER WASH, push in the cycle control knob, turn to the cycle time you want, pull knob out to start.
Other operating instructions For a rinse and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.] 1. Push Control Knob in. 2. Turn clockwise to any on the dial.
Cleaning the lint filter Clean filter after every load for best filtering results. NOTE: The load type will vary the amount of lint build-up. To clean: 1. Lift off the agitator barrel. 2. Wash or wipe the filter clean in the bottom of the agitator barrel.
Liquid fabric softener dispenser 1. Add detergent and load to the basket. 2. Add liquid fabric softener to the dispenser using the amount recom- mended on the bottle. 3. Avoid dripping or spilling any fabric softener on the load. 4. Dilute fabric softener with hot water.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off, this takes the pressure off the water inlet valve and hoses. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry.
Winterizing Because some water stays in the washer, freezing can cause a lot of damage. If your washer stored or moved during the cold weather... Shut off both water 2. Put a quart of R.V faucets. Disconnect or automobile and drain water antifreeze inlet hoses.
WHIRLPOOL” AUTOMATIC W&HER WARRANTY t WHIRLPOOL LENGTH OF WARRANTY FULL ONE-YEAR FSP@ replacement correct WARRANTY From Date of Purchase Service TECH-CARE” FSP replacement LIMITED FIVE-YEAR WARRANTY case assembly From Date of Purchase workmanship. shown LIMITED TEN-YEAR FSP replacement WARRANTY or fail to contain...