Table of Contents
Advertisement
Figure no. 12 illustrates the process:
Figure 12 – Pushing the Micro-BNC connector into place
Once pushed all the way through, twist the connector clock-wise. The pin will move in the channel locking the
connector in position:
Figure 13 – Twisting the connector and securing it in position
To remove the cable, repeat the process from finish to start: twist the connector counter-clock-wise and pull it
out. Do not force the cable out! If you feel resistance check for the pin location in relation to the channel. Adjust
as needed and only then pull the cable out.
Page no. 22 | Installation & Configuration
Advertisement
Table of Contents
