Ferno 082-2012 Manual

1.1 Description
This kit (Figure 1) includes two 12 Volt DC, sealed lead-acid bat-
teries to replace the batteries in the POWERFlexx
Pac. There are also two strips of hook-and-loop fastening material
to replace the strips in the POWERPac case if needed.
The person replacing the batteries should have a working
knowledge of basic electrical connections. If you do not feel
comfortable making the connections, contact Ferno Customer
Relations, EMSAR or your Ferno distributor (page 13).
ELECTRIC SHOCK HAZARD.
This equipment to be serviced
by trained personnel only.
1.2 Parts Supplied
2 ea ....................................Batteries (1 ea. labeled #1 and #2)
2 ea ...................................................... Hooked fastening strip
1.3 Tools Required
1 ea ......................................................#1 Phillips screwdriver
1 ea .............. 11/32˝ Wrench, nut driver, or socket and ratchet
4 ea ............................ 1˝ wide x 3˝ long Threaded Tape Strips
1.4 Hook-and-Loop fastener Notes
The hook-and-loop fasteners that secure the batteries in the
POWERPac are composed of two strips.
The hooked (rough textured) strips are affixed to the bottom of
the POWERPac case. They may need to be replaced with the
hooked strips provided in this kit.
The looped (fuzzy textured) strips are on the batteries, applied
at the factory.
1.5 Recycling the batteries
The batteries inside the POWERPac contain lead, which must
be disposed of properly through recycling.
Recycling in the United States of America is regulated by the
Environmental Protection Agency (EPA). Contact your state
EPA for recycling information in your area.
WEEE DIRECTIvE (E.u.)
European Union directive 2002/96/EC Waste Electrical and
Electronic Equipment (WEEE) limits the disposal of electrical
and electronic equipment in landfills. Contact the government
in the country in which you reside for recycling information.
© Ferno-Washington, Inc.
Cot POWER-
®
WARNING
u.S.A.
234-3388-01 June 2008
Parts Kit 082-2012
Replacement Batteries for
POWERFlexx
Hooked
Fastening
Strip (2)
Figure 1 - Kit Components (not shown to scale)
1.6 Safety Information
SAfETy NOTICES
Notices with the signal word "WARNING" indicate a poten-
tially hazardous situation which, if not avoided, could result
in injury or death.
Notices with the signal word "Important" emphasize important
usage or maintenance information.
Important
SAfETy LAbELS
Read and follow instructions on safety labels.
WEEE Directive:
Dispose of Properly
(Lead-acid batteries)
Cot
®
Battery
(2)
Installation
Instructions
234-3388-01
The safety label shown below is
affixed to each battery.
1