Table of Contents
Advertisement
Figure 4
Wall Mounting Procedure
1. Attach the unit piece of the wall mounting bracket to the back of the VHH10 unit with three M8 bolts, as
shown in Figure 4. Please notice that a single bolt attaches in the middle at the top of the bracket and
two bolts attach the bottom of the bracket. The holes in the top corner of the bracket are unused.
2. Attach the wall piece of the wall mounting bracket to the wall surface so that it is oriented as shown in
Figure 5. The side rails must be away from the wall so that the unit lays flat on the wall. The locking
flanges must be on the bottom as shown in this figure.
3. Attach the grounding cable to the grounding connection on the unit assembly, as described above.
4. Hang the unit assembly on the wall piece of the bracket by matching up the bracket side flanges and
sliding the unit assembly down onto the mounted wall piece until it rests on the locking flanges.
Veea, Inc. Confidential & Proprietary
6
Advertisement
Table of Contents
