Or-Fab HD Bumper Installation Instructions

INSTALLATION INSTRUCTIONS
WARNINGS/CAUTIONS
3651 N. Highway 89 • Chino Valley, AZ 86323
Before you install this kit, read and understand
(928) 636-3100 • www.orfab.com
all instructions, warnings, cautions, and notes in
this instruction sheet and in the vehicle owner's
JEEP WRANGLER JK
manual.
ROCK SLIDER REAR BUMPER
Proper installation of this kit requires knowledge
WITH LED BACK-UP LAMPS
of the factory recommended procedures for removal
and installation of original equipment components.
INSTALLATION INSTRUCTIONS
We recommend that the factory shop manual and
any special tools needed to service your vehicle
2007-2016
be on hand during the installation. Installation of
this kit without proper knowledge of the factory
WARNING
recommended procedures may affect the perfor-
Before you install this kit, read and understand all
mance of these components and the safety of the
instructions, warnings, cautions, and notes in this
vehicle. We strongly recommend that a certified
instruction sheet and in the vehicle owner's manual.
mechanic familiar with the installation of similar
components install this kit.
CAUTION
Proper installation of this kit requires knowledge of the Many states and municipalities have laws
factory recommended procedures for removal and
restricting bumper heights and "type". Consult
installation of original equipment components. We rec-
state and local laws to determine if the changes
ommend that the factory shop manual and any special
you intend to make to the vehicle comply with
tools needed to service your vehicle be on hand during
the law.
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
Always wear eye protection when operating
may affect the performance of these components and
power tools.
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
Before you install this kit, block the vehicle tires
ilar components install this kit.
to prevent the vehicle from rolling.
WARNING
OR-FAB Inc. recommends using the Loctite
Many states and municipalities have laws restricting
in the kit on the threads of all kit nuts and bolts
bumper heights and "types". Consult state and local
unless specified otherwise in these instructions.
laws to determine if the changes you intend to make to
the vehicle comply with the law.
If parts are missing from kit, please be prepared
to provide the following information:
WARNING
1. Name of purchase location
Always wear eye protection when operating power
2. Bar Code on side of box
tools.
3. Date above bar code
4. Date inside box cover
WARNING
5. Inspector # from inside box cover
Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.
NOTE
OR-FAB Inc. recommends using the Loctite® supplied
in the kit on the threads of all kit nuts and bolts unless
specified otherwise in these instructions.
421 MAIN STREET, RIVERSIDE CA, 92501
JEEP Wrangler JK Rock Slider HD
Rear Bumper |
Before Starting Installation
Item
HD Bumper
BEFORE STARTING INSTALLATION
1. Carefully read all warnings and instructions com-
2. Verify all parts have been received in this kit by
1. Carefully read all warnings and instructions
KIT# 83218
2. Verify all parts have been received in this kit
3. Only install this kit on the vehicle for
3. Only install this kit on the vehicle for which it is
4. Park the vehicle on a clean, dry, flat, level
4. Park vehicle on a clean, dry, flat, level surface and
Engine Compartment
ENGINE COMPARTMENT
®
supplied
| UNITED STATES
2007-2017
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
NOTE
pletely before beginning.
Kit parts are prefaced by the word kit
and appear in bold print.
checking the parts list at the end of this document.
NOTE
completely before beginning.
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
by checking the parts list at the end of this
3. Date above bar code
document.
4. Date inside box cover
5. Inspector # from inside box cover
which it is specified. If anytime during
the installation you encounter something
specified. If anytime during the installation you
encounter something different from what is outlined
different from what is outlined in the
in the instructions, call technical support at:
instructions, call technical support at the
(928) 636-3100.
number below.
surface and block the tires so the vehicle
block tires so vehicle cannot roll in either direction.
cannot roll in either direction.
Disconnect both battery cables. Disconnect nega-
tive cable first, then positive cable.
Positive Cable
| (951)-680-9595
Kit No.
83208/83268
Negative Cable
WWW.ORFAB.COM
|