Or-Fab 82301 Installation Instructions

2007-2012 JEEP WRANGLER (JK)
SPORT CAGE FLOOR MOUNT
INSTALLATION INSTRUCTIONS
KIT # 82301
WARNING
Read and understand all instructions, warnings, cau-
tions, and notes in this sheet and in the vehicle
owner's manual before you install this kit.
WARNING
Use extreme caution when working near glass. Sharp
objects in contact with glass could cause an explosion
of glass resulting in serious personal injury and prop-
erty damage.
WARNING
The purpose of the Sport Cage is to enhance the
appearance of the vehicle only. The Sport Cage is
NOT intended to protect the occupants of the vehicle in
the event of a vehicle rollover.

Before starting installation

NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Park the vehicle on a clean, dry, flat, level surface
and block the tires so the vehicle cannot roll in either
direction.

Prepare to install kit

NOTES
Begin installation where directed in the instructions for
kit # 82300 & 82350 Sport Cage.
You may need to remove any aftermarket rockrails in
order to gain access to lower mount bolts
1. Gain access to install area.
a. Pull out retainer clips from lower door frame
plastics.
Retainer Clips
b. Gently pull up rear plastic corner section just
high enough to allow the lower plastic piece to
come free.
c. Carefully pull off plastic piece from body. There
are 2 more clips that will pull out form side panel.
Do this carefully, to prevent breaking these clips.
d. Pull back carpet just far enough to gain access
to where the floor mount will sit. Clean up mount
area so it may sit flush on the floor.
1 Jeep Wrangler Floor Mount Kit 82301
Inner retainer
clips
Mount Area