Table of Contents
Advertisement
6.3
Deleting a LoRaWAN server configuration
Deleting a LoRaWAN server configuration is done using the following command:
client lora delete -i <gateway EUI> [ENTER]
This will delete the configuration based on the gateway EUI. For example, if we want to delete the
configuration we just added for LoRiot in the previous paragraph you would give the following
command:
client lora delete -i 402814FFFF01001E [ENTER]
The command should give the following output message:
LoRa configuration successfully deleted
You can list the available configurations to verify that the delete operation was actually performed
by giving the following command:
client lora list [ENTER]
Which should give you an output similar to:
LoRa gateway configuration "838240281401000e"
Forwarder address: "router.eu.thethings.network":1700
Please note: in the above example the packet forwarder will be stopped because now there is no
active configuration defined. You will have to configure the active LoRaWAN server after you have
deleted an active configuration.
rfi@s-gateway:~$ client lora delete -i 402814FFFF01001E
LoRa configuration successfully deleted
rfi@s-gateway:~$ client lora list
LoRa gateway configuration "838240281401000e"
Forwarder address: "router.eu.thethings.network":1700
Figure 5: Deleting a LoRaWAN server configuration
The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V.
QIG_S-gateway_v1.30.docx
Page: 8(11)
Advertisement
Table of Contents
