Gsm/gprs to rs-232 and ethernet gateway (21 pages)
Summary of Contents for RFI S-GATEWAY
Page 1
S-GATEWAY EU Picocell indoor gateway including a GPS receiver for advanced timekeeping Quick Installation Guide Author Ivo van Ling Hardware Release Quick Install Guide Version QIG_S-gateway_v1.30.docx Date 1-04-2019 Covering Product code RE.45.SGUE...
The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language without prior written consent of RFI Engineering B.V. QIG_S-gateway_v1.30.docx...
ISM bands, that complements M2M cellular infrastructure. It provides a low- cost way to connect battery operated and mobile devices to the network infrastructure. The S-gateway uses a command line management system whereby you can configure the unit through the command line interface using SSH.
All S-gateways will have a MAC address looking similar to: 40:28:14.xx.xx.xx, where the xx.xx.xx part will be specific to your unit. The MAC address of the S-gateway is also printed at the label attached to the bottom of the unit.
SSH client. In our example below the S-gateway has been assigned an IP address of 10.1.4.133 To connect to your S-gateway for the first time start your SSH client. Enter the IP address, User Name (rfi) and port number (22) for the S-gateway: Host Name: 10.1.4.133...
Only one packet forwarder process can run at any one time on the S-gateway. The configuration of the packet forwarder is done through a client utility that allows you to change the server address, the port number...
Configuring a different LoRaWAN server The default configuration of the Packet Forwarder on the S-gateway is for communicating with the TTN LoRaWAN servers. You can change this configuration using the build-in ‘client’ utility. In order to add a configuration, you type: client lora add -s <server address>...
The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language without prior written consent of RFI Engineering B.V. QIG_S-gateway_v1.30.docx...
Forwarder address: "router.eu.thethings.network":1700 In the example above there are two LoRaWAN servers configured. The one listed with * is the active configuration. Meaning; the S-gateway is currently forwarding the received LoRa packets to the servers of thethingsnetwork (TTN). rfi@s-gateway:~$ client lora activate -i 838240281401000e...
Get:7 http://cdn-fastly.deb.debian.org/debian stretch/main Translation-en [5,384 kB] Fetched 12.4 MB in 1min 19s (156 kB/s) Reading package lists... Done Now that the package list is updated, you can install the latest S-gateway software by giving the following command: sudo apt-get install s-gateway-rfi-build [ENTER] This fetches the latest S-gateway software from RFI Engineering’s servers and installs this on the...
Page 12
APT-Manual-Installed: no APT-Sources: http://apt.rfi-engineering.com/apt/debian stretch/embedded armel Packages Description: [generated from Rust crate s-gateway-rfi-build] Test Below is an example of a full software upgrade performed on an S-gateway. rfi@s-gateway:~$ sudo apt-get update Ign:1 http://cdn-fastly.deb.debian.org/debian stretch InRelease Get:2 http://cdn-fastly.deb.debian.org/debian stretch Release [118 kB] Get:3 http://apt.rfi-engineering.com/apt/debian stretch InRelease [1,625 B]...