Rear Panel Connections And Controls Pa410 - Arcam HDA PA720 Handbook

Rear Panel Connections and Controls PA410

VOLTAGE SELECT
Ensure that the voltage
selected matches the local
power supply.
POWER INLET
SUPPLY
VOLTAGE
SWITCH POSITIONS
110-120V/220-240V ~ 50/60Hz
115 = 110 - 120V ~
500W MAX 230 = 220 - 240V ~
POWER INLET
Connect the correct mains cable Connect your wired local network to one port.
here. The second port can be used to connect to
See "Network and RS232" on page EN-10.
RS232
This connection allows for remote control
from a third-party home automation
system or computer. For software upgrades only. See
See "Network and RS232" on page EN-10.
TRIGGER IN
NET RS232 USB
5V 100mA
TRIGGER OUT
(12V 100mA)
NETWORK
other devices
Trigger IN allows the PA410 to be turned on or off by an external source.
USB Trigger OUT allows the PA410 to control the power state of other connected
"USB" on page EN-10.
IN4 IN3 IN2 IN1
OUT4 OUT3 OUT2 OUT1
PRE-AMPLIFIER INPUTS
Connect the phono outputs of your
pre-amplifier.
See "Connecting Sources and
Loudspeakers" on page EN-13.
PRE-AMPLIFIER OUTPUT
OUT1 to OUT4 provide a copy
of the signal applied to the
IN1 to IN4 phono sockets.
Note: This is a passive output,
no additional filtering or
amplification is applied.
EN-9
TRIGGER IN / OUT
equipment
See "Trigger IN/OUT" on page EN-10.
CH4 CH3 CH2 CH1
CLASS 2 WIRING
4-16 OHMS
SPEAKER TERMINALS
See "Connecting Sources
and Loudspeakers" on
page EN-13.
Please read the sections "Placing The Unit",
"Power" and "Interconnect Cables" on page
EN-6 before connecting
amplifier!
EN
your PA410