Kohler K-3900X-2 Installation Manual page 7

Fig.#1
Connector
Harness
Fig.#3
Install the Remote Dock
NOTE: The docking station comes with a 5 meter cord. Locate the docking station to allow the docking cord
to reach the toilet.
Unpack the box containing the remote control components.
¨
Remove the small screw on the bottom of the docking station.
¨
Carefully remove the cover plate by plug the tool into the gap on the top of the back, gently prying the sides
¨
of the cover plate out until they disconnect from the dock. (see Fig. #2)
Carefully disconnect the cover plate plug.
¨
Tape the screw to the cover plate and set it aside.
¨
For installations using the concealed type, route the power cord through the back cord opening.
¨
For installations using the out-loading type, route the power cord through the bottom cord opening.
¨
Position the docking station in the installation position and mark the screw locations using the dock as
¨
a template.
Drill appropriate size mounting holes at the screw mounting locations. The size of the hole will depend
¨
on the need for wall anchors, wall material, and installation requirements.
Loosen each of the five small screws located where the wires will be connected.
¨
Run the power cord into the docking station through the back cord opening in concealed type or the
¨
bottom cord opening in out-loading type.
Position the docking station over the installation location, connect the docking station to the wall using two
¨
screws.
Cut the tin (about 2 mm) of the bare end of the wire.
¨
Slide the bare end of the wires into the correct port (see Fig. #3) according to the color and tighten each screw
¨
to secure the wires in place, connect the cover plate plug.
Snap the cover plate back into place.
¨
Remove the screw and tape from the cover plate and secure the cover plate with the screw to the docking
¨
station.
Kohler Co.
Screw
Orange
Blue
Red
White
Black
Docking Cord
Holes
Disconnect.
Fig.#2
Back Cord
Opening
Bottom Cord
Opening
Fig.#4
7
Back Cord
Opening
1195109-X2-A