Charging - Stihl BGA 56 Instruction Manual

Hide thumbs Also See for BGA 56:
Table of Contents

Advertisement

Available languages

Available languages

English
To set up the charger:
2
1
► Insert the plug (3) into a properly installed wall outlet (4)
matching the voltage and electrical frequency stated on
the charger's rating plate on the back of the charger.
The charger runs a self-test immediately after it is plugged
in. The charger LED (1) will glow green for about
1 second, then it will glow red briefly before going out.
Once the self-test is complete, the charger is ready to
charge the battery.
► Position the power supply cord (2) so that it will not be
stepped on, tripped over, come in contact with sharp
objects or moving parts or otherwise present a tripping
hazard or be subjected to damage or stress.

11.2 Charging

WARNING
STIHL batteries contain safety features and devices which,
if damaged, may allow the battery to generate heat, rupture,
leak, ignite or explode. Never charge a malfunctioning,
damaged, cracked, leaking or deformed battery or use a
charger that has been damaged. For indoor use only. Keep
the charger dry. Protect it from rain, water, liquids and damp
conditions. Never insert a wet battery or use a wet charger,
@ 11.2.
16
4
3
2
To charge the battery:
2
1
► Push the battery (2) into the charger (3) until it stops.
The LED on the charger (4) glows green when the battery
is being charged.
The LEDs (1) on the battery glow green and show the
state of charge.
When the LEDs on the battery turn off, the charging
process is complete and the charger will shut itself off.
► Remove the battery from the charger and disconnect the
power supply cord from the wall outlet when charging is
complete.
A new battery is not fully charged. STIHL recommends that
you fully charge the battery before using it for the first time.
Operate the charger only indoors, in dry rooms and within an
ambient temperature range of 41 °F to 104 °F (5 °C to
40 °C).
The battery heats up during operation of the blower. If a hot
battery is inserted into the charger, it may be necessary for
it to cool down before charging. The charging process
begins only after the battery has cooled down sufficiently.
Charging time depends on a number of factors, including
battery condition and the ambient temperature. For a
complete list of approximate charging times, see
www.stihl.com/charging-times.
11 Charging the Battery
3
4
0458-712-8221-A

Advertisement

Table of Contents
loading

Table of Contents