Tusk UTV Rear Window Instructions

1
Tusk UTV Rear Window Instructions
Polaris RZR XP 1000 and XP4 1000
Thank you for purchasing the Tusk UTV Rear Window. Please read through all the
instructions and examine the rear window to become more familiar with the straps and buckles
used for mounting.
1. Position the Tusk UTV Rear Window on the
back (outside) of the roll cage with the window
stitching and female buckles facing inward
toward the cockpit. Attach the two Velcro straps
on the top horizontal roll bar (see fig. 1).
2. Attach the top corners of the rear window.
Wrap the material around the bend in the roll
cage and attach each strap as shown in figure 1.
Leave straps loose.
3. Remove the seats for easy access to the back
panels/engine cover. Position the bottom of the
rear window between the seats and
engine cover (see fig. 2).
4. Loop the upper side straps
(located near the seatbelt mounting
bracket) around the seat belt
mounting bracket as seen in figure
3. Thread the strap back through
the buckle on the rear window (see
fig. 4). Leave somewhat loose at
this point.