Removal Of P-Module; Removal Of Lamp Unit - Panasonic PT-AE1000U Service Manual

PT-AE1000U / PT-AE1000E

6.10. Removal of P-Module

1. Remove the P-Module block according to the steps 1
through 7 in the section 6.9. "Removal of B/Q-Module".
2. Unscrew the 2 screws.
3. While pressing to shut each hook of the 2 resinous stands,
remove the P-Module.

6.11. Removal of Lamp Unit

1. Lift the rear side of the top panel and disconnect the top
panel Open/Close hook, then open the top panel.
2. Loosen the 3 screws until they idle.
3. Slide the lamp lock button to release, and remove the lamp
unit block (with lamp unit cover).
Note:
· When installing the lamp unit in the main unit, place
it in a specified position and press the connector
side and the opposite side of the lamp unit (arrow
positions shown in the figure below), and confirm the
lamp unit is inserted securely. Then, tighten the 3
screws fixing the lamp unit cover.
20