Black Box JPM1105A Manual page 12

4. To terminate the connection, place each wire into
the insulation displacement contacts (IDC) by
matching the wire color with the applicable colors
on the jack (568A).
We recommend untwisting the pairs no more than 0.5"
(1.3 cm) from the termination point.
5. If you are using a 110-type punchdown tool,
position the tool over each wire with the cutting
blade facing the outside of the IDC and punch
down firmly.
6. Repeat the process with each pair.
Figure 3-1. T568A wire colors.
NOTE
CHAPTER 3: Installation
9