Pre-Wash - Whirlpool 2LA5700XK Use And Care Manual

Before adding detergent for washing, dissolve In quart of warm water (or
use lrqurd detergent)
)/""1#Ei
Some stains may need a warm or cold PRE-WASH
to help prevent settrng
l
Is a fuse blown or circulf-breaker
tripped?
l
Are the water supply hoses kinked?
l
Is the Cycle Control Knob set and
pulled out7
l
Are the water inlet hose filter screens
clean7
To check the screens:
-Turn off the faucets.
- Remove hoses and check the
screens.
-Clean the screens under running
water.
- Replace the hoses and tighten
connectrons.
-Turn on the faucets and check
the leaks.
IF YOUR WASHER DOES NOT SPIN:
0 Is the Ird closed?
l
Is the power supply cord plugged in?
l
Is a fuse blown or crrcurt-breaker
tripped?
IF WASHER FILLS AND DRAINS WITHOUT
RUNNING:
l
Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
IF YOUR WASHER STOPS DURING THE
PERMANENT PRESS CYCLE.
l
Remember, the washer will stop for
about 1% minutes after the partial drain
during the cool-down perrod in this
cycle.
MAKE SURE THE DRAIN HOSE IS HIGHER
THAN THE WATER LEVEL IN THE WASHER.
IF IT ISN'T...
l
The washer may seem to be draining
during wash and rinse cycles.
l
Water can siphon out. [See lnstallatron
Instructions.)
11