Control 4 C4-BPS48 Installation Manual

Supported Model
C4-BPS48 Bus Power Supply, 48V
Introduction
The Control4® Bus Power Supply, 48V is intended for use in a Control4 system and
installs in a Control4 Panelized Lighting panel. The Bus Power Supply provides the
power to the Bus Ethernet Gateway and Control4 Configurable Wired Keypads.
Box Contents
Bus Power Supply
Bus Power Supply Mounting Bracket
Warranty Card
One (1) Ferrite Clamp
Two (2) Mounting Screws
Specifications
Model Number
Power Input
Power Output
Power Consumption
Connectors
Environmental
Operational Temperature
Humidity
Storage
Dimensions and Weight
H x W x D
Weight
Shipping Weight
Bus Power
Supply, 48V
Installation Guide
(this document)
C4-BPS48
100-240VAC, 50/60Hz
48VDC
100-240VAC at 1.8A
48VDC at 1.8A (or 86.4W)
One (1) Line Voltage Screw
Terminal one (1) Line, one (1)
Neutral, one (1) Earth Ground
One (1) low-voltage screw
terminal; two (2) 0V, two (2) 48V
32˚F to 104˚F (0˚C to 40˚C)
5% - 95%
Non-condensing
-4˚ F - 158˚ F
(-20˚ C - 70˚ C)
5.5" x 9.75" x 7.75" (139.7mm x
247.65mm x 196.85mm)
2.3 lbs. (1.04 kg)
2.85 lbs. (1.28 kg)
™
Warnings and Considerations
WARNING! The Bus Power Supply should be installed by a licensed
electrician in accordance with all national and local electrical codes.
ATTENTION! Le bus d'alimentation doit être installé par un électricien
certifié conformément à tous les codes électriques nationaux et locaux.
WARNING! Improper use or installation can cause SERIOUS INJURY,
DEATH or LOSS/DAMAGE OF PROPERTY.
ATTENTION! Une mauvaise utilisation ou installation peut entraîner des
blessures graves, décès ou perte / dommages à la propriété.
WARNING! This device must be protected by a circuit breaker (20A max).
ATTENTION! Cet appareil doit étre protègè par un disjoncteur (20A max.)
Use this device only with copper or copper-clad wire. Do
IMPORTANT!
not use aluminum wiring. This product has not been approved for use with
aluminum wiring.
IMPORTANT! Using this product in a mannner other than outlined in this
document voids your warranty. Further, Control4 is NOT liable for any
damage incurred with the misuse of this product. See "Troubleshooting."
IMPORTANT! This is an electronic device with intricate components.
Handle and install with care!
Front View
Figure 1. Front View
A
A Line Voltage Connector
B Low Voltage Connector
C Bendable Tab
D Mounting Bracket
B C
D