General Safety Rules - Bosch 1529B Operating/Safety Instructions Manual

Product Data - Corrugated Nibbler
Model number
Identification number
Nibbler Capacities:
Material
Mild Steel 60,000 PSI
Most Alum. 36,000 PSI
Stainless 87,000 PSI
Accessory Listing
Punch 2 608 639 027
Die 2 608 639 028
Carrying case
Corrugated Nibbler Components
1. Paddle ON/OFF switch
2. Wing screw
3. Housing
4. Punch
5. Sealing ring
WARNING!
"READ ALL INSTRUC-
TIONS". Failure to follow the SAFETY RULES
identified by the BULLET (•) symbols listed
BELOW and other safety precautions, may
result in serious personal injury. Keep these
operating instructions with this product.

GENERAL SAFETY RULES

for all Power Tools
Work Area
• KEEP WORK AREAS CLEAN. Cluttered
areas and benches invite accidents.
• AVOID DANGEROUS ENVIRONMENT.
Don't use power tools in damp or wet locations.
Do not expose power tools to rain. Keep work
area well lit.
• AVOID GASEOUS AREAS. Do not oper-
ate portable electric tools in explosive atmo-
spheres in presence of flammable liquids or
gases. Motors in these tools normally spark,
BM 3609929430 4-04
1529B
0 601 529 2 . .
up to
up to
up to
6. Die holder
7. Die
8. Rubber ring
9. Knurled nut
and the sparks might ignite fumes.
• KEEP CHILDREN AWAY. Do not let
visitors contact tool or extension cord. All
visitors should be kept away from work areas.
• GUARD AGAINST ELECTRIC SHOCK.
Prevent body contact with grounded surfaces
such as pipes, radiators, ranges and refrigerator
enclosures. Rubber gloves and non-skid foot-
wear are recommended when working out-
doors, where damp or wet ground may be
encountered. A Ground Fault Circuit Inter-
rupter protected power line must be used for
these conditions.
• DRESS PROPERLY. Do not wear loose
clothing or jewelry. They can be caught in
moving parts. Wear protective hair covering to
contain long hair.
• USE SAFETY EQUIPMENT. WEAR
SAFETY GOGGLES or glasses with side
shields. Wear hearing protection during ex-
3
3
Max. Sheet Thickness
18 Ga. (.048")
.080" (2mm)
20 Ga. (.036")
Personal Safety
4/22/04, 9:56 AM