Whirlpool 9872208 Use And Care Manual page 8

Raised Panel:
The outer section of panel must be
the trim. Use the dimensions shown when designing raised panel
sections.
(37.2 mm)
"
(5.6 mm)
A
B
"
(8 mm)
both sides
A. Raised panel or decorative trim
B. Outer section of panel
Trimless Panel with Handle
Dimensions
Use these dimensions drawings to create a custom panel for use
without a trim kit. The panel should be
16 mm) thick.
NOTE: A thicker panel may need rounded front corners and a
cutout for access to the handle.
15"
(38.1 mm)
8
" (5.6 mm) thick to fit into
14 "
1 "
(32 mm)
23 "
(60.5 cm)
"
(8 mm)
" to " (13 mm to
23 "
(60.5 mm)
Installation
1. Remove the mounting screws attaching the foot pedal to the
compactor. Remove foot pedal.
A
A. Mounting screws
B. Foot pedal
2. Remove mounting screws attaching the toe guard to the
compactor. Remove toe guard.
3. Remove the mounting screws attaching the decorative panel
to the compactor. Remove decorative panel and discard
mounting screws.
4. Align the bottom of the custom panel with the bottom of the
drawer front.
5. Secure the panel from the back using four #8 x 1" wood
screws as shown.
6. Reinstall the toe guard using the existing screws and
" washer. Then, reinstall the foot pedal.
A
B
C
D
E
F
A. Handle
B. Custom panel
C. Panel screw locations
D. Toe guard
E. Washer
F. Toe guard screw
A
B
C