Layout And Items Supplied - EINHELL TC-SB 200/1 Original Operating Instructions

ning.
53. Never use guards to lift or transport items.
54. Ensure that the bandsaw blade guards are
used and correctly adjusted.
55. Keep your hands a safety distance away from
the bandsaw blade. Use a push stick for nar-
row cuts.
56. When the push stick is not being used, keep it
in the holder provided on the machine.
57. Follow the instructions for adjusting the blade
tension and for guiding the blade with the use
of the supplied aids.
58. Always be attentive when using the ma-
chine so that you notice hazards early on
and can react to them. Timely intervention
can prevent serious injuries and material da-
mage.
59. Always wear gloves when handling the
saw blade or rough materials.
60. If problems occur, switch off the machine
and isolate it from the power supply. If
necessary, have the machine repaired by a
qualifi ed expert before you use it again.

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. ON/OFF switch
2. Power cord
3. Rubber tires
4. Web panel
5. Machine foot
6. Extractor socket
7. Lower blade pulley
8. Upper blade pulley
9. Tightening screw
10. Blade guard
11. Upper blade guide
12. Side cover
13. Hood closure
14. Retaining screw for upper blade pulley
15. Saw table
16. Dial scale for tilt angle
17. Plastic table insert
18. Fixing handles for saw table
19. Setting handle for blade guide
20. Fixing handle for blade guide
21. Clip for parallel stop
22. Setting screw for upper blade pulley
23. Motor
24. Parallel stop
25. Machine frame
26. Blade
Anl_SA_TC_SB_200_1_SPK8.indb 36 Anl_SA_TC_SB_200_1_SPK8.indb 36
GB
27. Tilt guard
28. Guide pin, top
29. Guide pin, bottom
30. Support bearing
31. Support bearing
32. Mount
33. Sockethead screw
34. Blade guard
35. Allen screw
36. Mount
37. Sockethead screw
38. Sockethead screw
39. Hexagon key 3 mm
40. Hexagon key 4 mm
41. Screw
42. Nut
43. Washer
44. Nut
45. Push stick holder
46. Push stick
47. Screw
48. Screw
49. Rubber foot
50. Hexagon key 5mm
51. Screw
52. Sockethead screw
53. Washer
54. Nut
55. Washer
56. Locking lever
57. Cover
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 36 -
26.11.2018 11:14:42 26.11.2018 11:14:42