Table of Contents
Advertisement
Instruction manual
16
How to prepare therapy
6. Plugging the nebulizer into the electrical power
Device can operate connected directly to mains electrical outlet (220V AC) or to a car
cigarette lighter adapter (12V DC).
Plugging into mains electrical outlet (220V AC)
Make sure that the power button
is in the OFF/0
⓮
position. If the power cord
is not attached, insert it
⓲
fully in the socket of the nebulizer
and plug it into an
⓰
electrical outlet.
Note: Mains socket outlet used for connection of the
control unit to the mains shall be easily reachable to the
operator.
Plugging into car cigarette lighter adapter (12V DC)
Connect DC power cable
running from car cigarette
⓳
lighter adapter to socket on the rear side of unit
.
⓱
Observe the keyhole at the top of the connector on DC
power cable
. Keyhole prevents wrong assembly of the
⓳
plug.
7. Turning the nebulizer on, pausing
Turn on power button
, on a back side of device.
⓮
Press Start/Stop button
to start therapy.
❿
It will start if the water tank is filled with cooling water.
If the water level in the water tank is too low, device will
signalise error trough blinking of Start/Stop button
.
❿
Fill water tank as described in section 2. Then press
Start/Stop button
again to start inhalation.
❿
You may temporarily pause the inhalation session by
pressing the Start/Stop button. The inhalation session may
be continued by pressing the same button again.
Advertisement
Table of Contents
