Removing The Crisper And Cover; Using The Ice Cube Trays; Using The Optional Automatic Ice Maker - Roper RTIZDK Use And Care Manual

Removing the crisper and cover
To remove the crisper:
1. Slide crisper straight out.
2. Replace crisper by sliding it straight in.
To retnove the cover:
1. Lift the back and slide it to the rear until the
front can be lifted.
2. Lii cover up and out.
To replace the cover:
1. Slide the front cover tabs into the rear of the
front supports on the refrigerator walls.
2. Lower back of cover into place.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using the optional automatic ice maker
If you plan to add an automatic ice maker later
(Part No. IMKIT), there are a few things you will
want to know:
l
The ON/OFF lever is a wire signal arm.
Down . . . to make ice automatically.
up . . . to shut off the ice maker.
. .
NOTE: Do not Ucn ice Won until It IS
Gonnected to the water wwl~. lnstructlons
hook up WC
mached to the back of the refrigerator
cabinet.
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
Shake the bin occasionally to keep cubes
separated and to obtain increased storage
capacity.
l
It is normal for ice crescents to be attached by
a corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't
let these sounds bother you.
Raise
signal
arm to
stop ice.
Lower
signal
arm to
start it