Removing Freezer Trivet; Removing Freezer Basket (Bin); Freezer Shelves; Removing And Adjusting - Whirlpool RS20CK Use And Care Manual

To replace covers:
To adjust:
1. Fit cover frame notches into
1. Remove shelf as above.
supports on walls of refrigerator.
2. Slide supports upward and remove.
2. Lower into place. 3. Slide supports downward into new
3. Slide back of crisper cover glass
position.
insert into place; then lower front.
4. Replace shelf.
Removing freezer trivet
NOTE:
The cup-shaped supports go in the
(Model RSZOCK)
back of the freezer.
For proper air movement, keep freezer
Changing the light bulbs
trivet in place when the refrigerator is
operating.
To remove trivet:
1. Lift trivet up.
2. Pull trivet forward.
To replace trivet:
1. Slide trivet into freezer.
2. Lower trivet into place.
Removing freezer basket
(bin)
(Models
RS22AR and RS25AW)
To remove:
1. Slide forward to the guide stops.
2. Lift front until it clears stops.
3. Slide out the rest of the way.
To replace:
1. Place on the slides.
2. Lift slightly until the stops clear the
front of guides.
3. Slide in the rest of the way.
Removing and adjusting
freezer shelves
To remove shelf:
1. Remove food from shelf.
2. Lift right side of shelf off wa.ll
supports.
3. Slide left side of shelf out of
supports.
4. Replace in reverse order.
Electrical Shock Hazard
Unplug the refrigerator or discon-
nect the main electric power
supply to the refrigerator. Failure
to do so can result in electrical
shock or injury.
To change refrigerator light:
1. Disconnect refrigerator from power
supply.
2. Remove the bulb from the socket
located behind the Control Console
and throw the burned-out bulb
away.
3. Replace with a 40-watt tubular
appliance bulb.
4. Reconnect power supply.
To change freezer or crisper light
(on some models):
1. Disconnect refrigerator from power
supply.
2. Grasp front of light shield.
3. Pull bottom of shield forward until it
snaps free.
4.
Remove bulb.
5. Replace with a 40-watt appliance
bulb.
6. Press light shield straight on until it
snaps into place.
7. Reconnect power supply.
To change upper freezer light
(RS25AW):
1. Disconnect refrigerator from power
supply.
2. Lift top of light shield up and pull
shield out.
3. Remove bulb from socket.
4. Replace with a 40-watt appliance
bulb.
5. Place shield over bulb and snap into
place.
6. Reconnect power supply.
To change dispenser light
(RS25AW):
1. Disconnect refrigerator from power
supply.
2. Remove bulb from the socket inside
the dispenser area.
3. Replace with a heavy-duty, lo-watt
bulb.
4. Reconnect power supply.
NOTE:
Not all commercial appliance
bulbs will fit your refrigerator. Be sure to
replace a bulb with one of the same size
and shape.
Removing the base grille
Metal clips
Defrost pan
To remove:
1, Open the refrigerator and freezer
doors.
2. Pull grille outward.
3. Do Not remove Tech Sheet fastened
behind grille.
To replace:
1. Line up grille support tabs with
metal clips.
2. Push firmly to snap into position.
3. Close the refrigerator door.
See cleaning instructions for defrost pan
and condenser coils on page 9.
Page 6