Removing The Base Grille; Changing The Light Bulbs - Roper RT20DKXDN00 Use And Care Manual

Removing the base grille
To remove the base
grille:
1.
Open the refrigerator door.
2. Grasp the grille with both hands.
3. Push down on the top edge of the grille to
release the top clips.
4. Roll the grille toward you to release the
top clips.
5. Pull grille away from the refrigerator.
NOTE: Do not
remove the Tech Sheet
fastened behind the grille.
To replace the base grille:
1.
Line up the edges of the grille with the
outside edges of the cabinet.
2. Roll the grille toward you.
3. Place the lower clips in the openings in
the metal panel.
4. Roll the grille toward the cabinet until the
top clips snap into place.
5. Close the refrigerator door.
See cleaning instructions for defrost pan and
condenser coils on page 19.
Condenser
Defrost
coils
pan _.
-
C&s
Changing the light bulbs
Electrical Shock Hazard
Before removing a light bulb or removing
a light shield for cleaning, either unplug
the refrigerator or disconnect the electrii-
ity leading to it at the main power supply.
Failure to do so could result in electrical
shock.
To change refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind Control Panel to remove bulb.
3. Replace with a 40-watt appliance bulb.
4. Reconnect refrigerator to power supply.
NOTE: Not all commercial appliance bulbs will
fii your refrigerator. Be sure to replace a bulb
with one of the same size and shape.
16
WITH QUESTIONS OR COMMENTS