Removing The Ice Maker Storage Bin - Roper RS20AKXDN00 Use & Care Manual

ice maker mold and lead to poor ice quality.
If a softened water supply cannot be avoid-
ed, make sure the water softener is
operating properly and is well maintained.
Removing the ice maker storage bin
(on some models)
Remove, empty, and clean the storage bin if:
l
the ice dispenser has not, or will not, be
used for a week or more.
l
a power failure causes ice in the bin to
melt and freeze together.
l
the ice dispenser is not used regularly.
To
remove Ice bin:
1.
Pull the covering panel out from the
bottom and slide it to the rear.
2. Lift the signal arm so it clicks into the OFF
(up) position. Ice can still be dispensed,
but no more can be made.
3. Lii the front of the storage bin and pull
it out.
4. Empty the ice bin. Use hot or warm water
to melt the ice if necessary. Never use
anythlng sharp
to break up ice in the bin.
This can damage the bin and dispenser
mechanism.
5. Wash with mild detergent. Rinse well. Do
not use harsh or abrasive cleaners or
solvents.
6. When replacing the bin, make sure it is
pushed in all the way. Then push the
signal arm down to the ON position to
restart ice production.
15