Download Print this page

Advertisement

Quick Links

HiVi DIY3.1-A Speaker Kit Manual
www.hivi.us

Advertisement

loading
Need help?

Need help?

Do you have a question about the DIY3.1-A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HiVi DIY3.1-A

  • Page 1 HiVi DIY3.1-A Speaker Kit Manual www.hivi.us...
  • Page 2 Please read the manuals carefully first. If you ever have any problems, feel free to email us at support@hivi.com. There is also a great community of DIY builders at www.reddit.com/r/diyaudio/. If you’re ever looking for completely built speakers please check out our website at www.swanspeakers.com.
  • Page 3 7) 1Ohm resistor (R3) 11) 6.8uF capacitor (C3) 4) 0.6mH air inductor (L2) 8) 3.3uF capacitor (C1) 12) 10uF capacitor (C4) 13) HiVi RT 1.3-B isodynamic ribbon tweeter 14) HiVi DMN-B dome midrange driver 15) HiVi L6-4R woofer 16) Vent Tube...
  • Page 4 Enclosure Division Front Side Side Back Bottom 17) Cabinet front (x2), Back (x2) Bottom (x2), Side (x4), Division (x2) 19) Cushions for drivers and terminal box...
  • Page 5 21) Screws E. Female threads 8 PCS A. Screws for woofer 16 PCS F. Male threads 8 PCS B. Screws for midrange driver and G. Retainers 10 PCS terminal box 16 PCS H. Holding pegs 10 PCS C. Screws for tweeter 8 PCS D.
  • Page 6 1. Arrange the components as illustrated in the figure below. With a soldering iron, apply solder to the connections between the components and the board. Remove the excess components legs and secure the inductors with cable ties. Note: Remove the coating on either end of the inductors to ensure good contact.
  • Page 7 I 、Enclosure Assembly 1. Set the enclosure parts out on a flat level surface. Apply some wood glue to the locating groove in the side panel and install the division panel into the groove. Then apply glue to all the contact surfaces between the panels. And place all the other panels in place.
  • Page 8 4. When the glue is dry, knock the 5 retainers into the holes in the bottom panel. And then turn the 5 holding pegs onto them or just knock the 5 screws into the retainers. Install 4 female threads into the holes in front panel. 5.
  • Page 9 7. There are two sets of lugs on one side of the terminal box and two sets of connected terminals on the other. Weld the input wire on crossover to either set of lugs through the terminal box hole. Again the polarity must be correct. (red = positive) Make sure that there is no short circuit or false welding.
  • Page 10 9. Apply a layer of glue to the frame of the grill and tuck the grill fabric into the groove in the frame cut the excess fabric. Knock the 4 male threads into the holes in the frame. If you wish, attach the logo on the bottom edge in the circle slot.
  • Page 11 HiVi USA HiVi Acoustics, Inc. 11630 Goldring Road,Arcadia,CA 91006,USA Tel:+1 626 930 0606 Fax:+1 626 930 0609 Due to the reasons in the change of design or others, product information contained here may not be in conformity with product itself. We reserve the right of no prior notice before change.