Advertisement
Using Your Refkigerator
Setting the controls
Controls for the refrigerator and freezer
are in the refrigerator. When the
refrigerator is plugged in for the first
time:
1. Set the Refrigerator Control to 3.
2. Set the Freezer Control to B.
R&igerat0r control
3. Let the refrigerator and freezer
compartments get cold for several
hours before adding food.
4. When the refrigerator keeps milk or
juice as oold as you like and the
freezer compartment keeps ice
cream firm, the settings are correct
for your household.
mttd01
moisture
control
Changing control settings
1. Adjust the Refrigerator Control
according to the settings listed in
the chsrt below.
2. Wait 24 hours or more before
making additional adjustments to
the Refrigerator Control or
adjusting the Freezer ControL
mm~
control
Refrigerator section
Condition
TOO WARM
Check if
8 Door is opened often.
. Large amount of food added.
. Too-warm room temperature.
Set control settina
Refrigerator
4
Freezer
B
Freezer section
TOO WARM
Both sections
TOO WARM
Refrigerator section
TOO COLD
8 Door is opened often.
. Large amount of food added.
. Too-cold room temperature
(freezer can't cycle often enough).
8 Door is opened often.
l
Large amount of food added.
8 Too-warm or too-cold room
temperatures.
8 Controls not set correctly.
Refrigerator
3
Freezer
Between
BandC
Refrigerator
Freezer
;
Refrigerator
4
Freezer
Between
BandC
Ice is not made
fast enough
8 Heavy ice usage.
m Very cold room temperature
(freezer can't cycle often enough).
Refrigerator
3
Freezer
Between
BandC
Exterior moisture control
The Exterior Moisture Control operates
electric heaters around the door
openings. These heaters help keep
moisture from forming on the outside of
the refrigerator.
1. Use the OFF setting when humidity
is low.
2. Use the ON setting if moisture
forms on the outside of the
refrigerator.
fd.d.~it~g refrigerator
Shelves can be adjusted to match the
way you use your refrigerator.
To remove shelf:
1. Remove food from shelf.
2. Tilt up at front.
3. Lift up at back.
4. Pull shelf straight out.
To replace shelf:
1. Guide the rear hooks into the slots
in the shelf supports.
2. Tilt up front of shelf until hooks
drop into slots.
3. Lower front of shelf into position.
Page 4
Advertisement
