Operating Instructions
Lowering Tower - (From Upright Position)
•
Loosen screw E.
•
Rotate tower to line up arrows.
•
Tighten screw E.
•
On the Electric Winch Controls panel, move winch circuit breaker to the ON position.
•
Operate winch B EXTEND control switch to the DOWN position to lower tower.
•
Remove lock pin C.
•
Operate winch A RAISE control switch to the DOWN position to lower tower to
horizontal position.
•
Insert and lock pin D before moving or lifting.
•
On the Electric Winch Controls panel, move winch circuit breaker to the OFF
position.
Before Moving
•
Chock tires. Raise jacks.
•
Swivel all jacks to horizontal position and pin in place.
•
Withdraw outrigger locking pins and slide both outriggers to stored position. Install
locking pins.
•
Operate winch B EXTEND control switch to the DOWN position to lower tower.
•
Remove lock pin C.
•
Operate winch A RAISE control switch to the DOWN position to lower tower to
horizontal position; insert and lock pin D before moving or lifting.
•
Insert and lock pin D before moving or lifting.
•
On the Electric Winch Controls panel, move winch circuit breaker to the OFF
position.
Operating & Maintenance Manual
31