DAGU Doodle Bot Manual page 9

Make sure the robot is turned off and connect it to your computer with a USB cable. The control board will be
powered by the USB cable while you upload the program but there will be no power to the motors. Go to the
"Tools" menu and select your USB serial port.
From the "Tools" menu choose the board type. The Doodle Bot controller is compatible with an Arduino NG or
older using an ATmega8 processor.
When you upload the program you will see a message indicating the program is compiling, then uploading.
When the upload is complete you can disconnect the USB. The robot is ready to go! Note: It is normal for the
robot to wait a few seconds before the program runs.