This manuał is intended to serve as a supplément to the FTM-2001 Operating Manual. Detailed
information regarding functions, spécifications, options and operation has been provided in the
Operating
Manual,
serve as an independent reference, but to be used in conjunction with the information provided
in the Operating Manual.
Because of the compactness and complexity of the double-sided glass-epoxy circuit boards used
in the FTM-2001, four layout diagrams are provided for each board. Each side of the board is
identified by
the type of the majority of components installed on that side.
one side has
only chip components, and the other has either a mixture o f both chip and lead
components
(trimmers,
only.
The two "obverse" views depict the board as it is seen when viewed directly with the
eye, while the two "reverse" views depict the unseen side o f the board as it would appear if
one were to
peer through
tracks on the near side.
While we believe the technical information in this manuał is correct, Yaesu assumes no liability
for damage that may occur as a resuit o f typographical or other errors that may be present.
Your coopération
appreciated.
Yaesu Musen
reserves the right to make changes in the circuitry of this transceiver, in the
interest o f technological improvement, without notification o f the owners.,
FTM-2001 SERVICE MANUAL
and is not reprinted herein.
coils, electrolytic capacitors,
the board from the other side without seeing the components and
in pointing
out any inconsistencies in the technical information would be
Therefore,
this manuał is not intended to
packaged ICs, etc.), or lead components
In most cases