Table of Contents
Advertisement
Removing and adjusting the freezer
To remove shelf:
1. Lift front slightly
2. Lift back off supports.
3. Replace
in reverse order
To adjust shelf:
1. Remove shelf.
2. Remove supports by sliding upwards.
3. Replace
supports on desired level.
4. Replace
shelf.
Ice cube trays.. .
cold air starts a slow evapotction.
The longer cubes
are stated, the smaller they get.
If cubes are not used, they may shrink. The moving
To remove ice:
1. Hold tray at both ends.
2. Slightly twist.
Optional automatic ice maker.. .
If you have the automatic
ice maker accessory
or
plan to add one later [Part No. ECKMF-83), there are
a few things you will want to know:
l
The ON/OFF
lever is a wire signal arm.
Down., .for making
ice automatically;
Up...toshut
off the ice maker.
l
Shake the bin occasionally
to keep cubes sepa-
rated, and to obtain
increased
storage capacity.
l
It is normal for ice crescents to be attached
by a
corner. They will break apart easily.
On
Lower Signal
\
Raise Signal
Arm to Start it.
Arm to Stop ice Maker.
l
Ycu will hear water
running
when ice maker
is
working.
You'll hear ice fall into the bin. Don't let
these sounds bother you.
l
The ice maker will not operate
until the freezer is
cold enough to make ice. This can take overnight.
l
Because
of new plumbing
connections,
the first
ice may be discolored
of off-flavored
Discard the
first few batches
of ice.
l
If ice is not being made fast enough and more ice
is needed,
turn the Refrigerator
Control toward
a
higher number. Wait a day and, if necessary,
turn
the Freezer Control toward A.
l
If you remove
the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin.
push it all the way in and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop
an
off-flavor...like
stale water. Throw them away. They
will be replaced.
Cubes
in the ice bin can also
become
smaller by evaporation.
l
Good waterquality
is important
for good ice
qUalitV
It is not recommended
that the ice maker be con-
I
netted
to a softened
water supply. Water softener
chemicals
such as salt from a malfunctioning
soft-
ener can damage
the ice maker mold and lead to
poor quality ice. If a softened water supply cannot
be avoided,
then it is important
that the water
soft-
ener be well maintained
and operating
properly.
Advertisement
Table of Contents
