John Lewis Roman blind Instructions

Roman blind
Thank you for purchasing this product. Please read the instructions and
warnings carefully before use to ensure safe and satisfactory operation of
this product. It is recommended that this blind should only be installed by
persons competent in DIY.
Cord stops are attached to keep the blind in the locked position to
prevent the risk of strangulation prior to fitting. Please remove the cord
stops before fitting the blind and then reattach following the cord stop
instructions once your blind has been fitted.
Please check the contents
60cm & 90cm blinds
1. 2 x Fixing brackets
2. 4 x Screws and wall plugs
3. 1 x Safety cleat
120cm, 150cm, &180cm blinds
1. 3 x Fixing brackets
2. 5 x Screws and wall plugs
3. 1 x Safety cleat
Please note: Additional fasteners other than those sent with your blind
may be required depending on the mounting surface. Wallboard and
plaster require the use of anchors such as expansion or toggle bolts. Brick,
tile or stone need special plugs and drill bits. Remember to always pre-drill
holes in wood to avoid splitting.
1. Positioning the blind
1. A Inside the recess
Decide the position of the blind so that it will be clear of any
latches and fixtures.
I. B. If you need to reduce the width of the blind to fit the recess,
this should be done before assembling.
1. C. Outside the recess
Decide the position of the blind so that the overlaps on both
sides are equal. It is advisable to allow a minimum of 5cm
overlap on each side.
2. Fixing the brackets
2. A. Please ensure that the head rail for this blind is installed at least
1.5m from the floor.
2. B. The brackets are designed for face or top fixing to the window
frame, wall, or ceiling.
2. C. Attach the brackets to the headrail by inserting into the
channel on the reverse.
2. D. Having decided the positioning of the blind, present it to the
desired position, making sure it is centred and level.
2. E. Mark the location of each bracket with a pencil.
2. F. Remove each bracket from the headrail by pressing the locking
tab at the bottom of the bracket.
2. G. Place each bracket on its location markings and mark through
the desired screw hole positions.
2. H. Use the screws provided to fix the brackets to wood. For
masonary, use masonary plugs.
1.
2.
1/3