Advertisement
PREPARATION
WARNING
・Be sure to turn off the angle grinder and remove the plug from the electrical outlet in advance.
・If the connector is loose and cannot be securely attached on the angle grinder, do NOT use HURRICANE in this state.
otherwise it could lead to injury.
Grinder
INSTALLATION
1. Choose the correct components for Angle Grinder to be used, according to the following table.
Brand
HITACHI
G13SR3/G13SB3
Model
etc.
Connector
[e]
Collar
Flange
Spacer *
* When using a diamond cup wheels with the height 21mm.
2. Change the Connector. (if needed)
(1) Loosen the screws by [k] Wrench and
remove the preset connector.
Screw
Washer
(2) Set the correct Connector and tighten the
screws. (Don't forget to fit the washers)
Screw
Washer
-2-
Take the Guard off from the Grinder.
Guard
DEWALT
FLEX
D28134 etc.
L3410FR etc.
[g]
[m]
T7.3
iD16
[p]
[ k ]
Pre-set Connector
( [d] M-Connector )
[ k ]
[ f ]
Clamp Piece
When using [f] B-connector,
take the Clamp Piece apart
before setting.
O-Ring
MILWAUKEE
AG8-125Q etc.
AG12-125X etc.
[h]
(Standard Flange)
T4.5
[n]
3. Fit on an Angle Grinder.
Hold 3points of the Connector and tighten
the fitting screws. (2pls.)
WARNING
Make sure HURRICANE is securely
attached, otherwise it may come loose,
causing injury.
Fitting screw
FLEX /
Milwaukee (AG8/AG9 series)
TORX screw
Tighten 3pcs of TORX screws as
fitted to the angle grinder.
GWS8-115/GWS8-125/GWS10-125/
GWS11-125CI/GWS14-125CI
Remove O-Ring
if it is equipped.
BOSCH
MAKITA
9558NB/9565CV/
GWS8-125 etc.
GA4530 etc.
[d]
(Factory Preset)
[m]
T4.5
[n]
Metabo
[ i ]
Clamp Piece
Put [ i ] Collar between a Clamp
Piece and angle grinder.
METABO
GWS14-125CI etc.
WE14-125 Plus etc.
[ f ]
[ i ]
(Standard Flange)
T7.3
[o]
Advertisement
