Advertisement
Quick Links
BEFORE YOU BEGIN:
Verify location of underground utilities before you dig!
•
Locate property lines.
•
Review local and regional building codes, regulations and zon-
•
ing laws which may affect your fence.
Obtain all necessary permits as required by local building codes
•
The Santa Fe and Mesa Fence's versatile, modular design allows for a multitude of configurations suita-
ble for flat, sloping and uneven terrain.
Step Configuration
Variable Height Configuration
Santa Fe & Mesa Fence 6' X 6'
Installation Instructions
TOOLS REQUIRED:
Tape Measure
Stakes
String Line
Spray Paint
Post Hole Digger & Shovel
Wheel Barrow
(also for 4' and 8' high)
Level
Drill with 3/16" Nut Driver
9/16" End Wrench
9/16" Socket
Miter Saw
Metal Cut-Off Saw
Slope Configuration
Advertisement
Summary of Contents for Natures Composites Santa Fe
- Page 1 Metal Cut-Off Saw Obtain all necessary permits as required by local building codes • The Santa Fe and Mesa Fence’s versatile, modular design allows for a multitude of configurations suita- ble for flat, sloping and uneven terrain. Step Configuration Slope Configuration...
-
Page 2: Bottom Bracket
PARTS LIST Every Santa Fe and Mesa fence kit comes standard with the following components. 3/8”-16 X 1/2” BOLT SELF DRILLING SCREW 3/8”-16 LOCK-NUT 4 PCS for 6 ft tall 2 PCS 4 PCS for 6 ft tall 6 PCS for 8 ft tall... - Page 3 INSTALLATION DOS AND DON’TS Before installation always store fencing materials on a flat surface in a dry location. Don’t allow packaged materials to be rained on, snowed on or exposed to water. Don't use hammer or other tools to install composites fence boards. Do allow for proper air flow under your installed fence.
-
Page 4: Post Installation
POST INSTALLATION Dig post holes in locations determined earlier. The recommend hole size is shown in figure above; however, installer should consult with local and region building codes for proper post footer design. Each six-foot panel requires a post at each end. The posts with an adjacent panel must be bolted together before the posts are set in concrete. - Page 5 AS IT MAY DAMAGE THE COMPOSITE FENCE BOARDS! 4. On Santa Fe Fences, the last board may extend above the top of the post, or be too far below the top of the post. If this happens, simply adjust the Bottom Rail Brackets to achieve the correct alignment .
- Page 6 307-532-9943 Fax 877-810-4029 Toll Free Natures Composites’ products are manufactured in the U.S.A. and distributed through retail and wholesale channels throughout the United States, Canada, www.naturescomposites.com Mexico and Europe. Learn more about Natures Composites and our products by visiting www.naturescomposites.com...