Sears CRAFTSMAN SLEEVE HITCH Owner's Manual page 8

FIG. 7. Turn the ignition switch "ON". Push the
attachment lift switch to the "Down" position
to retract the electric
actuator.
Tum the
ignition switch "OFF".
NOTE: Full retraction of the actuator is
achieved by turning the tractor height adjust­
ment knob counter-clockwise (fJ).
FIG.B. Remove the 1 3/4" bolt from the
middle of the shaft assembly arm that
connects the right and left hand lift
brackets. Then remove the five washers
(Fig.8A)
and
install the drawrod tube "A"
as shown in Fig.9
NOTE: The 1 3/4" bolt must be reinstalled from
the center of the tractor - with the nut on the
FRAME SIDE to prevent interference. Do not
tighten at this time.
THE FIVE WASHERS ARE NOT USED
WHEN ASSEMBLING 46" DOZER LIFT
MECHANISM OR SLEEVE HITCH.
[ = - - - - ­
wwm.,CM'
-;:;-EIGHT4
DJ~~b~ENT~ ~
FIGURE 7
---..,4-1---_:
----1\....L.t-,.4ll.....
VIEWED FROM R.H. SIDE 0
---­
-
-­
LIFT
SHAFT---...
ASSEMBLY
ARM
RACTOR
FIGURE 8
8