Sears CRAFTSMAN SLEEVE HITCH Owner's Manual page 7

~
NOTE: ON OLDER UNITS IT MAY BE NECES­
SARY TO REMOVE THE LEFT HAND LIFT
LINK AS SHOWN IN FIG. 4.
FIG. 4. Remove the left hand (L.H.) lift link from
tractor as follows:
Remove the two hex washer head screws in
cover plate and remove nut"A" (Fig. 4. inset) to
FIGURE 4
release the lift link from tractor. Then replace
cover plate and secure with the two hex washer
head screws.
IF ELECTRIC KIT IS TO BE INSTALLED,
OMIT FIGURE 5. REFER TO ELECTRIC
I ASSIST KIT INSTALLATION FIG.9 FOR
!
I ...
i
I . ASSEMBLY OF SLEEVE HITCH. THEN
II
~ROCEED
THROUGH STEP 6 OF ASSIST
t
1--
<IT MANUAL.
/
,a.
5. Assemble drawrod assembly (13) to the
,At shaft assembly arm located under the left
lland side of tractor. Align the two holes in end
of drawrod assembly with the hole in the lift
shaft assembly arm and insert the( lift arm pin)
1/2" x 1" clevis pin (9). Secure assembly by
inserting retainer spring (7) through hole in
end of clevis pin (9).
r
DRAW ROD
QASSEMBLY
tl
~
13
~/
RETAINER
SPRING7
001£: FOLLOW THE PROCEDURES IN
FIGURE 6,7,8 and 8A FOR INSTALLING
THE DRAWROO ASSEMBLY (13) IF YOUR
TRACTOR IS EQUIPEO WITH A PRE ­
INSTALLED ELECTRIC LIFT - BEFORE
CONTINUING TO F1G.10.
FIG. 6. Remove the bolt and nut at (B) which
I";onnect the electric actuator to the right and
left hand lift brackets.
NOTE
SOL T MUST START FROM
LEFT TO CLEAR TRACTOR FRAME
FIGURE 6
7
l