Using The Light Off Function; Using The Auto Clean Function - LG W3NQ12LNNP1 Owner's Manual

Window (inverter) air conditioner

Hide thumbs

Table Of Contents

Table of Contents

OPERATION

Clean Filter

The Clean Filter LED lights up to notify you that

the filter needs to be cleaned. After cleaning the

filter, Press TEMP

control panel to turn off the Clean Filter light.

NOTE

● The filter reset must be done using the control

panel, not the remote control.

● This feature is a reminder to clean the air filter

for more efficient operation. The LED light

turns on after 250 hours of operation.

Fan Speed

Press to set the Fan Speed to Low (F1),

Medium (F2), or High (F3).

Temperature Control

The thermostat monitors room temperature

to maintain the desired temperature. The

thermostat can be set between 16 °C–30 °C

(60 °F–86 °F). Presss

increase or decrease temperature setting.

Energy Saver

In this mode the compressor and fan turn off

when the set temperature is achieved.

Approximately every 3 minutes the fan turns on

to allow the unit sensor to accurately determine

if more cooling is needed.

Clear

Cancel Sleep and Timer settings. Also set the

Diagnosis if held for 5 seconds.

NOTE

• Auto Restart: If the air conditioner turns off due

to a power outage, it will restart automatically

once the power is restored, with the same

settings as were set before the unit turned off.

• Energy Saver: The unit defaults to the Energy

Saver mode each time the unit is switched on

except in Fan mode or when power is restored

after an electrical power outage.

• The remote control will not function properly if the

AC infrared sensor is exposed to direct light or if

there are obstacles between the remote controller

and the air conditioner.

and

together on the

arrows to