Before Using Your Refrigerator - Whirlpool 3ET22DKXDN00 Use And Care Manual

Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, and level it.
Cleaning your refrigerator
Removing packaging materials
NOTE: Do not remove any permanent
Remove tape and any inside labels (except
instruction labels inside your refrigerator. Do
the model and serial number label) before
not remove the Tech Sheet fastened under
using the refrigerator.
the refrigerator at the front.
To remove any remaining tape or label
glue:
Cleaning it before use
l
Rub briskly with thumb.
After removing all packaging materials, clean
your refrigerator before using
OR
it, if necessary. See cleaning
l
Apply liquid hand-dishwashing detergent to
instructions on page 17.
area before removing glue as described
' u
above. Do not use sharp instruments, rub-
bing alcohol, flammable fluids, or abrasive
q
cleaners. These can damage the material.
See "Important Safety Instructions" on
page 3.
Plugging it in
Recommended Grounding Method
A 115 Volt/GO Hz (Plug 1) 220/240 Volt/50
Hz (Plug 2), 220 Volt/GO Hz or 220/240 Volt/
50 Hz (Plug 3) AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.
Plug 1
Plug 2
Plug 3