PAC 202 Quick Start Manual page 8

One-Touch™ Test Mode
To speed up installation and testing, One-Touch™ testing is provided which allows the
controller functionality to be tested at the controller or reader.
Test
Normal
Operation
One-Touch™
View Mode
One-Touch™
Active Mode
Reader and
Request to Exit
Test
8
Action
Hold down the One-
Touch™ button for less
than 2 seconds.
Present keys and press
RTE switches and
observe LEDs.
Automatically exits after
2 minutes
Hold down the One-
Touch™ button for 2 to
4 seconds.
Present a key to each
reader (the lock will
activate).
Press the Request to
Exit switch (the lock will
activate).
Observation
Controller
The green system status
LED flashes at normal
rate.
Door status LEDs off.
The green system status
LED flashes at normal
rate.
Green on -valid key has
been presented to reader
Green flash - invalid key
has been presented to
reader
Red on - door open
Yellow on - RTE switch
has been pressed
The green system status
LED flashes faster than
normal.
The door green LED
flashes once for SIGA,
twice for SIGB.
The door green LED
flashes three times and
the yellow LED is lit.
Reader
The normal operation
of the reader.
The normal operation
of the reader LED
changes, e.g. if default
is red, it turns green.
The reader LED
flashes once for SIGA,
twice for SIGB.
The reader LED
flashes three times.
17642v3.0