Fujitsu PRIMERGY TX600 S2 Options Manual page 35

Processors
Removing the heat sink dummy
CPU 1 CPU 2 CPU 4 CPU 3
Figure 15: Dummies on the CPU sockets 2 - 4 (rear view of the server)
Ê Undo the four captive screws at the foot of the heat sink dummy on the
relevant processor socket and remove the dummy.
I
Please note: The numbering of the CPUs/CPU sockets corresponds
with the fitting sequence.
Installing the processor
Figure 16: Opening the socket lever
Ê Release the socket lever by pressing it sideways and lifting it up as far as it
will go.
U41612-J-Z156-2-76
Installing additional processors
Options Guide 31