Haier HWF5300AW User Manual page 15

English
5) Rinse Level
to Eco which gives you the least.
Baby Care rinse level gives extra rinse time to remove any soap ad detergent left on clothes
after wash. While Eco. rinse would normally be used on quick wash, Hand wash, Delicates
or Silky where extra rinse time may not be needed.
6) Spin Speed
change the preprogrammed selection. Selection here may vary per the cycle chosen. All
selections are not available in all cycles. Certain clothes are not recommended to be spun
at high speeds. Please see clothes manufacturer recommendation for best results.
7) Water Temperature (Wash / Rinse)
per the cycle chosen. All selections are not available in all cycles. Follow fabric care
labels for best results.
8) Beeper (Signal)
selection of cycles or options and when wash programs is completed. At the end of
washing cycle the unit will sound 3 long beeps. Signal will sound every 10 minutes after
the wash cycle to alert you. When choosing an option, if signal beeps twice it means that
the option is not available.
9) Extended Spin
drying time. Once the wash load is in the spin cycle this button can not be activated.
10) Stain Treat
11) Rinse& / Spin
or hanging in the closet for a long time may not only need to be rinsed and spun to make
them feel fresh again
Touch button to select this option. The washer will now switch off the wash mode and will
be in the rinse and spin cycle. Touching the button for a second time will set the washer to
spin only.
The rinse and spin speeds could be changed by touching their respective buttons (5 & 6).
The "Wash" "Rinse" & "Spin" icons by the Time Display Zone (16) will be lit to indicate the
selected function.
12) Delay
so, touch the delay button. Each touch of this button advances the delay in one hour
increments. To set the delay function touch the Start / Pause (3) button. Doing so will cause
the delay (12) button to flash. When set at 24:00, push the delay button again and the
delay time is cancelled. After setting if wash program is change delay time is cancelled.
13) Prewash
the main wash to the wash cycle. The RINSE &/ SPIN option can not be selected if this
function is activated.
Note: Remember to add detergent to the Prewash compartment of the dispenser drawer.
14) Custom Program
options and touch the "Custom Program" button (Approximately 3 Seconds) until a beep
confirms the settings. A maximum of 10 programs can be stored. To use your saved
13