natus ErgoJust Installation And Functionality Manual page 46

ErgoJust and ErgoJust ICU Cart Installation and Functionality Guide
3-20
IMPORTANT: Press all four screws inwards until they are tight against the Video Pole
(Figure 9) when performing the next step. This is necessary to position both brackets properly
in order to slide the brackets into both grooves on the bottom mast.
Figure 9: Press in all four screws tight to the Video Pole.
12. With an assistant, carefully lower the Video Pole onto the bottom mast, ensuring that both
brackets slide inside the two slots (Figure 10).
Figure 10: Proper placement of the mounting brackets inside the bottom mast slots.
13. Tighten all four screws until they are firm against the Video Pole (Figure 11).
Figure 11: Tighten all four video pole mounting screws.
14. Wiggle the Video Pole. There should not be any movement. If the Video Pole moves, the
brackets did not slide inside the two slots. Remove the Video Pole and repeat this procedure
beginning with step 12.
August 22, 2017