Table of Contents
Advertisement
August 22, 2017
NOTE: Confirm that the Video Pole is seated properly on the lower mast (Figure 5). If it is not
seated correctly, the brackets did not slide into the two slots. Remove the Video Pole and repeat
step 4 above.
Correct
Figure 5: Confirm the Video Pole is seated correctly on the lower mast.
5. Insert and tighten all four Video Pole mounting screws (Figure 6).
Figure 6: Insert and tighten all four Video Pole mounting screws.
6.
Tighten all four screws until they are firm against the Video Pole (Figure 7).
Figure 7: Tighten all four video pole mounting screws.
7.
Wiggle the Video Pole. There should not be any movement. If the Video Pole moves, the
brackets did not slide inside the two slots. Remove the Video Pole and repeat steps 4 and 5.
ErgoJust Cart System
Incorrect
3-7
Hide quick links:
Advertisement
Table of Contents
