Table of Contents
Advertisement
10. Connect the compressor hoses to the feed table
assembly. The sucker wheel hose threads through the
ty-rap and table support, underneath the feed table,
then onto the end of the sucker wheel shaft tube, as
shown in fig. 13.
Blower
Fittings
11. Attach the air hoses from the ends of the pile guides
to the double hose fittings of the blower. The single
hose from the sucker wheel fitting attaches to the
vacuum fitting, (fig. 14).
NOTE: Make sure all shipping plugs are removed
from the pump openings before attaching the
hoses!
10
Cleaning
A clean machine will reflect in the quality of the work it
produces. As you unpack your folder, wipe off any
excess protective oil, dirt, or dust which may have ac-
cumulated during shipping.
Keep your machine clean, and wipe off any
accumulations of paper dust at the end of each
day. Cover your machine anytime it is not in
use. See the maintenance section for addi-
tional cleaning instructions.
(fig. 13)
820 ONLY: Whenever the machine is not being
used, reinsert the roller spacers shipped in the
machine to prevent flat spots from forming. This
is a operator controled maintenance function.
Roller flat spots are NOT COVERED under war-
ranty.
CAUTION: DISCONNECT THE POWER BEFORE
INSTALLING THE ROLLER SPACERS.
1. Close the deflectors on both fold plates.
2. Place one roller spacers at each side of the
Vacuum
feed table and feed between the rollers with
Fitting
the hand wheel.
3. Remove the spacers before running the next
job.
(fig. 14)
NOTICE
F.669-D/820-870/Jan 98
Advertisement
Table of Contents
