Washing The Machine - Technogel FREEZER 200/1 Instructions For The Installation, Use And Maintenance

 Washing the machine
Once production of ice-cream has been terminated, connect the same mixture pipe to a tank containing
water (maximum temperature 70°C) mixed with detergent and disinfectant.
For the type of detergent and disinfectant Technogel advises the customer to request information
from a specialized company such as DIVERSEY/LEVER or HENKEL etc. who will supply a specific
product for this purpose.
NEVER USE CHLORINE TO DISINFECT AS THIS WOULD DAMAGE THE INTERNAL
Pump the water out of the machine by pressing the pump button
and start the stirrer
Repeat the operation until the water coming out is clean.
DURING WASHING OPERATIONS, THE REFRIGERATION COMPRESSOR MUST
DO NOT LEAVE THE TURBINE IN OPERATION IF THERE IS NO WATER IN THE MACHINE. EVEN IF THERE IS
WATER IN THE MACHINE THE MACHINE SHOULD NOT BE LEFT IN OPERATION AS IT WILL GIVE EXCESSIVE
WEAR AND TEAR ON THE BUSHINGS AND BLADES. OPERATE FOR 10 SECONDS AND THEN STOP FOR 30
SECONDS AND CONTINUE WITH INTERMITTENT USAGE UNTIL WASHING IS COMPLETE.
When washing is finished, it is essential to empty the refrigeration pipe completely of any residual
washing water. Follow the instructions below:
A) Disconnect power to the control panel by
pressing the "START" button (light off).
B) Unscrew the three handwheels (4) and dismantle
the flange (5) complete with faucet (2).
C) Remove the turbine (6) from the freezer pipe
taking care to dismantle, as they are extracted,
the scraper knives (7). Do not drop them.
D) Dry all the dismantled pieces and the inside of
the freezer pipe.
E) Before re-assembling the various pieces, grease
all the washers on the faucet, packer gland of the
turbine (see page 12) and flange with vaseline.
MAKE SURE THE SCRAPER KNIVES ARE ASSEMBLED CORRECTLY (see page 12).
SURFACES OF THE MACHINE
.
, turn on the ice-cream outlet faucet
20