Technogel FREEZER 200/1 Instructions For The Installation, Use And Maintenance page 12

Instructions for dismantling mixer turbine:

first time then
Check that the "EMERGENCY" button 11 (page
10) is off and that the power supply to the control
panel is therefore disconnected.
Using the appropriate spanner, dismantle faucet
2 by unscrewing ringnut 1. Unscrew handwheels
4 using the appropriate spanner and dismantle
flange 5 by pulling towards you.
Remove turbine 6 from the freezer tube and, as it
is being extracted, dismantle scraper knives 7.
While dismantling the knives protective gloves
must be worn as the knives are very sharp indeed
and you could cut yourself very easily.
When dismantling, do not drop them as they
could dent.
CHECKING THE DIRECTION OF ROTATION
Check that the "EMERGENCY" button 11 (page
10) is ON and connect the power supply by
pressing the "RESET" button 1 (page 10).
Press the stirrer button 5 and watch the hub to
check which way it rotates by looking through
into the inside of the freezer tube.
It must rotate in a clockwise direction
If it does not do so, disconnect the power supply
and invert any two of the three phases of the
machine power supply cable. Test again to check
the direction of rotation.
TAKE CARE WHEN HANDLING THE KNIVES AS THEY ARE VERY SHARP
AND YOU COLD CUT YOURSELF
12